MI00353-2-EN
ENGLISH 2/5
1.0 DISCLAIMER
Before execution any operation it is advised to read all the content of this
manual. Only electrical-skilled technicians can use the module described in this
installation manual. It’s installer's responsibility to assure that the installation is
in compliance to the security standards regulated from the law.
Only the Manufacturer is authorized to repair the module or to replace
damaged components.
The warranty is void in case of errors resulting from improper use,
modifications or repairs carried out by Manufacturer-unauthorised personnel
on the module.
3.0 TECHNICAL SPECIFICATIONS
3.1 Input
Connection
Passing wire
Hole diameter
21 mm; 0,8 Inch
2.0 DESCRIPTION AND GENERAL SPECIFICATIONS
2.1 Description
The T201DC100 is an isolated and passive, contact-less loop powered direct current
transducer. The T201DC100 has functions and look very similar to a standard current
transformer, but it is enabled to measuring the continuous current component that flowing
through it. For its electrical endurance, ease of use and compact dimensions, the
T201DC100 fits every kind of current measurement up to 100 Adc.
2.2 General specifications
- Suitable for solar panels, batteries, battery charger,power units and generic DC load.
- No shunt, no power consumption from the measure circuit
- High accuracy rating: class |0.2|
- Loop-powered 4 – 20 mA, 6 to 28 V, protected from reverse polarity and
transient up to 120 V, surge up to 1.5 J.
- Eight scales unipolar or bipolar selectable via dip switches
- Damping filter available to improve the stability of reading
- Reading of current pulsed or alternating currents with superimposed components
- Built-in microprocessor system fault check
- Over-temperature protection
- "single wire" possible wiring by powering with the device from the measuring current itself
and closing to the system common return.
- Possibility of mounting on the DIN rail through the support provided in the sales package.
SENECA s.r.l.
Via Austria, 26 – 35127 – PADOVA – ITALY
Tel. +39.049.8705355 - 8705359 - Fax +39.049.8706287
Manuals and configuration software are available at www.seneca.it
