User Manual
RM169-1
Pag. 19
Doc. MI004760-E
Rev. 0
www.seneca.it
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
Modbus timeout:
Represents the time interval (in hundreds of milliseconds) within which the modbus answer on the packet sent
by the Master unit must be received.
Cycle Update
:
In this field the time of the periodical transmission is set. The time base is selectable between seconds, minutes
or hours. The time range can vary from one second (minimum) to 255 hours (maximum). In this field you cannot
insert a value less than the time interval assigned to the field "External node boot time".
Its address:
Contains the value of the address of this radiomodem. Each unit must have a unique address. In the Master
device the maximum value of this field is dependent on the number of units in the network (parameter selected
in the field "Unit quantity").
Target address:
This field sets the value of the destination address. In the Master units, this field must contain the same address
used in the field "Its address" of the Slave unit. In the Slave units this field is not taken into account because the
mode "RX Address for TX" is used in the response packet.
When a device working as digipeater this value is uninfluenced.
System Code
(
double click of the mouse on "Target" or [Enter] key
):
When the focus is on the Target field, pressing the "Enter" key on the keyboard or by double clicking the mouse,
a window opens in which you can enter the system code.
The system code must be the same for all the
radiomodem in the network
.
