ENGLISH - 6/8
Electrical Connections
8 mm
0,2..2,5 mm
2
The module has been designed for spring-type terminal
electrical connections.
Proceed as follows to make the connections:
1 - Strip the cables by 0.8 mm
2 - Insert a screwdriver in the square hole and press it
until the cable lock spring opens.
3 - Insert the cable in the round hole.
4 - Remove the screwdriver and make sure that the cable
is tightly fastened in the terminal.
MI00124 -E
2
The configuration may be written to memory with the DIP-switches in any position, but the
saved parameters are used only with all the DIP-switches in OFF position.
%
Start and Full scale values.
%
RTD Connection: 2 wires, 3 wires or 4 wires.
%
50 / 60 Hz Rejection: Absent or Present.
%
Measurement filter: Absent or Present (1, 2 , 5 , 10, 30, 60 seconds).
%
Output: Normal (4 - 20 mA) o Reversed (20 - 4 mA).
%
RTD Type: PT100 or NI100.
%
Cable Resistance Compensation for 2 wires measurement.
%
Output signal in case of fault: t
or t
owards the bottom of the output range
owards the top
of the output range.
It is besides possible the calibration of the output scale.
The module may be programmed even if it is not supplied by the 4 20 mA loop, since the
-
power supply is provided through the programming connector.
The interface to program the module is available under the the frontal cover:
Once the user has at his disposal the above listed accessories, the following parameters
may be set:
1
5
6
2
Programming
K120RTD
