EN-4
EN
Vacuum Sealer
SVS 4010SS
2020
05/2020
appliance during the warranty period may void the warranty.
■
To prevent the risk of injury by electrical shock, never submerge the appliance and its power cord in water or any
other liquid, or wash these parts under running water.
■
In the event that the appliance falls into water, under no condition reach for it, rather, immediately disconnect
the power cord from the power socket. Never use an appliance that was submerged in water. Hand it over to an
authorised service centre for inspection.
■
Always turn off the appliance and disconnect it from the power socket when you have finished using it.
Safety during use
■
This appliance is intended for home use exclusively. Do not use this appliance for commercial purposes.
■
Do not use the appliance in an industrial environment or outdoors. Do not use it for any other purposes than
those intended.
■
This appliance is not intended to be operated using an external timer switch or a remote control system that would
enable this appliance to be turned on automatically.
■
Use the appliance and its accessories in accordance with the instructions contained in this user’s manual.
■
Only use the appliance with the original accessories that came with it.
■
Do not place the appliance on an electric or gas stove or in its vicinity, on a kitchen sink drainboard, on the edge of
a table, on window sills or on unstable surfaces. Always place it on a stable, even and dry surface.
■
Do not place the appliance in the vicinity of wash basins or sinks or near heaters, open fires or other sources of heat.
■
Only use the appliance when installed in its working position and located at a sufficient distance from flammable
surface such as curtains, drapes, etc.
■
Do not expose the appliance and its accessories to the outdoor environment, extreme temperatures, direct sunlight,
excessive humidity or excessively dusty environments.
■
Do not use the appliance if it has fallen on the floor, if it was submerged in water, if it is not functioning correctly
or if it is damaged in any other way. Before every use, check the appliance for damage.
■
Only use quality vacuum sealer bags and rolls intended for vacuum sealers.
■
Make sure that water or any other liquid does not enter into the air exhaust inlet.
■
The appliance heats up during operation and remains hot after operation as a result of residual heat. Avoid contact
with hot surfaces.
■
The appliance is equipped with a thermal fuse that turns it off upon overheating. In the event that such a situation
occurs, disconnect the appliance from the power socket and allow it to cool down. Then you may continue using it.
■
Do not touch the seal immediately after it is created. There is risk a of burns.
■
Do not touch the gasket strip, rubber strips or the foam gasket as this could damage these parts. These parts heat
up when the permanent seal is created. Do not touch these parts immediately after the seal is created.
■
Do not turn on the appliance when it is empty. Incorrect use of the appliance may negatively affect its lifetime. Do
not leave a running appliance without supervision.
■
A rest period of at least 40 seconds should be implemented between the sealing cycles to allow the appliance to
cool down. Leave the lid open during the rest period. The maximum operating time is 15 minutes. Then allow it to
cool down for approximately 30 minutes.
■
Do not perform any maintenance on the appliance apart from the cleaning procedure described in chapter
Cleaning and maintenance.
■
In order to prevent a hazardous situation arising, do not repair the appliance yourself or modify it in any way. Have
all repairs performed at an authorised service centre. By tampering with the appliance, you risk voiding your legal
rights arising from unsatisfactory performance or quality warranty.
■
Store the appliance in a dry environment.