6
【
2
】
Notes for Usage of the Automatic Feeding System SIDAF80
WARNING
1. Regarding how to use the Core Drill and notes for usage, read the instruction manual of the Core Dill
carefully until you understand, then use properly by following the instruction.
2. Make sure to be grounded.
●
In case of malfunction or electric leakage, connect the grounding plug to the power point sockets and
ground it due to the cause of electric shock.
●
Use the grounding and the power supply installed the earth leakage circuit breaker for electric shock pre-
vention.
3. Be careful of leaking the slurry water.
●
Be careful not to get the water on the control box during working due to using the water.
●
Control box is not designed for rainproof and waterproof, so do not use it where rain or a lot of moisture.
4. Regarding the operation of high-place work, please follow the applicable laws and regulations.
●
Secure the safe scaffold, and do not operate the machine 1.5 m higher than the scaffold.
●
When you work at high place, secure the enough scaffold space and secured scaffold.
●
When you work at high place, keep any person away under your working area.
5. Be sure to wear the rubber gloves and the rubber shoes.
●
Wear the rubber glove and the rubber boot during working due to using the water.
6. Use the proper voltage which is indicated on the nameplate.
●
Use the proper voltage which is indicated on the name plate of the Core Drill.
●
If you use the Core Drill over the indicated voltage, the rotation of Drill Motor will be high speed which will
cause the injury.
7. Properly connect the plug of the Drill Head and the waterproof connector.
8. Turn off the switch immediately when the abnormal is confirmed.
●
When the Core Bit stops or the abnormal sound generates, turn off the switch by pressing drill button.
CAUTION
1. Adjust the Core Drill.
●
The drill carriage adjustment is needed in order not to being rattled for the pole base and the drill carriage
of the Core Drill.
2. Away from direct sunlight.
●
If the surface temperature of the control box increases more than 40°C, the control function could not oper-
ate properly. If you use the machine outside, away from direct sunlight.
3. Warming up is needed If you use the Core Drill in the cold place.
●
The control function will not operate under - 5°C. If you use the machine under such condition, wait for 30
minutes after turning on the power switch and do not start the operation until the inside of the temperature
increases.
※
Do not warm up directly by using the stove or the burner.
4. Be careful of cutting.
●
When starting to cut to the cutting object, operate manually. After the core drill cuts 5 mm for the cutting
object by the feeding handle of Drill Head, then, operate the automatic feeding.
5. Be careful of not being caught in your body or the power supply cord into the feeding handle of Drill
Head during the operation.
