13
Logic Changer 24V
010 - > Tube $00.15
Logic Changer 24V
005 - > Tube $00.05
5¢
was
inserted
Coin
went
to...
Value of
coins
in...
10¢
was
inserted
Coin
went
to...
Value of
coins
in...
Test your coin changer with many different coins, at least to cover the
low sensors. Ideally, you should insert enough coins into the changer
to fill the tubes to the top and then see if the extra coins go to the
cashbox. (Special note for Canada: When you insert a two-dollar coin,
the display will prompt that a 1$ coin was inserted. However, note
that the amount was increased by two. This is because the 2$ signal
does not exist in a Logic changer. The 1$ signal is simply sent twice.)
One test you
MUST
also perform is to disable the ACCEPT LINE on the
CT3 and insert big and small coins. All coins
MUST
be rejected when
the Accept line is OFF. If it does not come out of the changer, it means
the return path of the changer is jammed. Test the coin return lever as
well.
Once the test is complete, it is now time to empty the tubes you just
filled. Press on the corresponding button (5¢, 10¢, 25¢) to dispense
from each tube. You can press more than one button at a time. The
changer will dispense from all tubes. When the tubes are empty,
pressing on any buttons will stop the payout.
Press STOP before unplugging the coin changer.
Once everything tested and cleaned, you can slip your coin changer in
a bag, write a short memo and put that changer on a shelf.
If some components of the coin changer are defective, such as the coin
acceptor or the tube sensors, you can swap some of the parts with an-
other defective coin changer having a different problem. This way,
instead of sending out two or three coin changers, you may send out
only one for repair.
Summary of Contents for The Vending Tester PRO CT3
Page 1: ...Last revision April 2012...
Page 2: ...2...
Page 6: ...6 Identification of the control panel on the CT3...
Page 27: ...27 EBVM Pin out specifications...