17
Warning 1
The timer offers two end-of-time warnings if you have the SLB module. The
moment those warning will active is programmable here. The first warning last
for 5 seconds only et will start at the moment you program here (i.e. 00:30).
Therefore, when the time left reaches 30 seconds, the beeper will sound 5
times.
Warning 2
The second warning will last for the time you program here and last till the
very end of the time cycle. If you program 15 seconds, the beeper will sound
for the ultimate 15 seconds.
Aux. Output time:
The timer has an auxiliary output that will activate at the very end of the cycle
and last for the timer programmed here. This output is located on the 6-screw
auxiliary terminal block, at positions 1 and 5. A perfect example would be an
exhaust fan expulsing humidity outside the shower. The maximum time it can
run is 30:00. Note that the output voltage is 24vdc (see page 6).
Minimum charge chrono
Minimum Charge chrono is grace period following a time cycle where a cus-
tomer can add credits to the timer without having to insert the minimum
charge. This delay only applies if the timer has been set to Continuous in the
Session mode (see page 12). The maximum time is 5 minutes or 300 sec-
onds.
Message *Welcome*
It possible to program a personalized welcome message that will be visible on
the 4-line display, alternating with the default messages. Each line has 20
characters, including spaces. Therefore, this message
Welcome to camping
has 18 characters. Use the Red or Blue buttons to navigate through the many
characters available. They include accents, low-case and high-case letters
and numbers.
Message *Out of order*
It possible to program a personalized welcome message that will be visible on
the 4-line display, if the timer goes out of order. Each line has 20 characters,
including spaces. Therefore, this message
Contact Front Desk
has exactly 18
characters.