15
The Technician Mode is reserved for person having a technical skill. You can-
not access this section by accident. To access it, press AND hold both the
Red and Blue buttons for at least three seconds.
This section divides in two menus:
System setting
Test mode
(still in development)
System setting:
The is where you will program some very specific parameters of your timer.
Use the programming flow chart to the left to help you navigate in the parame-
ters.
Language
The timer can display in English or in French but not both at the same time.
When visible on the display, press on the Green button to see the current set-
ting. Press on the Red button to modify it and Green to confirm your new set-
ting.
Machine ID
If you are operating a fleet of timers, you can apply a specific ID to each of
them. You can have numbers and letters as well as some special characters
like ? or >. When visible on the display, press on the Green button and the
first available space will blink. Press on the Red or Blue button to reach the
desired character. Press on Green to move digit. If you keep the Green but-
ton depressed, you will go back to the precious character. This machine ID
will be visible at the top of each audit print-out.
Beeper loudness
This is where you will program the volume of the beeper located into the SLB
Module. This beeper beeps 5 times when the remaining time is 30 seconds
and for the last 15 seconds bought. There are 10 sound levels with level 0
being mute.
Rate vs time display
You can show or not the rate on the timer. The display will then toggle be-
tween the coins accepted (i.e.: 25¢, $1 & $2), the minimum deposit (i.e.: Mini-
mum deposit $0.50) if any, and the rate (i.e.: 1.00$ */ 4m). If you set it to
NON, the rate will not be displayed.