8
508.366.1488 | www.semshred.com
3.
Power Supply/Installation Requirements
Intended Use:
The SEM Model 2SSD is intended to shred and disintegrate solid state drives and electronic media. It can reduce
media down to a particle size of 2x2mm depending on the size of the screen chosen. Larger screen mesh sizes are
available for larger particles and faster throughput. For additional information about destruction of other media
see “Shreddable Materials” and “Unacceptable Materials” sections.
Warning:
The Model 2SSD is not intended to destroy rotational hard drives. Inserting a rotational hard drive into
this device will catastrophically damage the unit and void the warranty.
Important:
The electrical installation of this device must be completed by a licensed electrician who is versed in
the applicable electrical codes of the country/region in which this device is being installed.
Phase:
All Model 2SSDs are designed for 3-phase electricity.
Voltage/Frequency
Full Load Amps (FLA)
Apparent Power (Line to Line)
Recommended
Disconnect
208/60
19 FLA
6.8 kVA
30 Amp
230/60
17 FLA
6.6 kVA
30 Amp
460/60
9 FLA
6.6 kVA
20 Amp
380/50
10 FLA
6.2 kVA
20 Amp
400-415/50
10 FLA
6.6 kVA
20 Amp
Note:
Model 2SSD should be connected to a dedicated circuit regardless of voltage.
Connection Information:
All Model 2SSD units are supplied with an open-ended power cord unless specified when
purchasing. This should be directly hardwired to a power disconnect switch mounted in close proximity (1-2 feet
away) to the unit. See attached electrical schematic for further details.
Panels:
All electrical panels contained within this unit carry a rating of IP65.
Side Outlets:
This unit is equipped with an IEC60320 outlet (120/1/60 or 220/1/50) and a 6-pin Amphenol
connector.
