SELMI TOP EX, User And Service Manual

Page: 22 / 55

Operation section
User and service manual
– TOP EX – Continuous tempering machine
20
If the mixer is rotating in the correct direction carry out
the following steps:
1)
press the “mixer command” button (section
5.1, button C); the blade in the tank (mixer) will
stop moving
2)
press the “restore functions” button (section
5.1, button I); the machine will produce an
acoustic signal
3) turn off the machine by pressing the
emergency button
When the testing of the rotation direction is completed,
the installation procedure can be continued as
described in the following sections.
4.3. Installation of the machine
After positioning the machine and connecting it to the
electrical supply, do as follows:

Clean the supplied accessories (see section 6)

Install the protection grill on the tank
Attention
Make sure that no objects used during
installation have been left in the tank; if so,
remove them.

To carry out this operation it is necessary to
correctly attach the grill side fastener to joint
shown by the arrow A (see picture below)

Positioning of the vibrating table
To carry out this procedure it is necessary to align the
vibrating plate support springs (B) with the pivots on
the machine (C).

Connection of the vibrating table
To complete the installation procedure of the vibrating
table it is necessary to insert the plugs (E) into the
sockets located at the side of the machine (E).
4.4. Commissioning
Check that all of the above-described procedures were
done correctly.
Check that the emergency button is not pushed; if it is,
release it.
Power-on the machine by pressing the button on the
main switch. The LED on the control panel will light up
to show that the machine is in STAND-BY.
Check that the safety and emergency protections and
control devices are working correctly.
Make sure the work zone is free of all objects not
needed for work and that there are no oil stains on the
floor.
A
A
B
B
C
C
E
E
D
D