INTRODUCTION | This Package and SP LINK
Doc #OI0003 Part #004122 Rev19 2014
|
7
Included in this package
• Mounting bracket
• Rear Outlet Mesh Cover (SPLC models only)
• Contents check list, checked and signed by Selectronic
• Know Your SP PRO display quick reference card
• Warranty card.
• Tool kit - (Hex Drive bits - T10 Torx, T20 Torx, T25 Torx, 5 mm Hex, 6 mm Hex, long extension)
• SP LINK software, this manual and helpful information packaged on USB Memory device
• USB Cable - Type B
Glossary of Terms
DC Coupled system Where the Solar is connected to the DC side of the inverter system through a Solar
Controller.
AC Coupled system Where the Solar is connected to AC Side of the inverter system via a separate Grid Tie
inverter.
Solar Hybrid
A battery based system that is connected to the electricity grid
Off Grid
A battery based power system that is remote from the electricity grid
AC Source
The primary AC input that is connected to the SP PRO, e.g., Mains Grid or Auto start
Backup Generator.
Site File
An SP LINK file that is set up for each SP PRO inverter to be connect to.
Configuration File
Contains all the settings to be loaded into the SP PRO. This is normally linked to a site
file
Solar Array
A collection of Solar Panels.
PV
Photo Voltaic solar power
State of Charge
(SoC) Referring to the battery charge condition. 100% SoC means a full battery.
Sealed Battery
A lead acid battery with no access to the electrolyte - either valve regulated or gel. No
hydrogen gas discharge during normal operation.
Flooded Battery
A lead acid battery with access caps for maintaining the electrolyte - replacing water
lost during recharge operations. Hydrogen gas discharged during normal recharge
SoC
State of Charge is the amount of charge in the battery bank expressed as a % of the
battery capacity. When SoC = 100% the battery is fully charged. When the SoC is 50%
then the battery is half charged.
Benefits of SP LINK
Provided with the SP PRO inverter is a free copy of the SP LINK software, a convenient configuration and
monitoring tool used for integrating the SP PRO into the energy system.
SP LINK accesses a host of monitoring and logging features in the SP PRO to allow the user and installer to
keep an eye on the system performance.
A PC running SP LINK is simply connected to the SP PRO via a USB port to open up the full potential of the
SP PRO Energy System
