SERVICE | Service and Maintenance
64
|
Doc #OI0003 Part #004122 Rev19 2014
S e r v i c e a n d
M a i n t e n a n c e
C h a p t e r E l e v e n
Cleaning the Fan and Fan filter
1. Ensure fan is stationary
2. Remove the four retaining screws that hold the fan filter in place.
3. Clean the filter mesh with a soft brush or similar implement.
4. Check to see if there are any foreign matter that could impede the fan operation.
5. Replace filter and tighten the four retaining screws.
All other maintenance on the SP PRO should be performed by a Selectronic Accredited Integrator.
Above the fan filter is a safety grill. Do not remove this grill – fast moving fan blades can cause
injury
Monitoring the Operation of the SP PRO
Installing SP LINK software onto a PC also installs SP LINK Auto QuickView. This program is a shortened
version or SP LINK designed to automatically connect to and display information about the SP PRO.
Using this program allows the following items to be monitored on a regular basis:
•
BATTERY VOLTAGE
(QuickView Tab)- this should
NEVER
be below the nominal system voltage - 24 V,
48 V or 120 V
•
BATTERY SoC%
(QuickView Tab) - a high average figure will maintain good battery life
•
The AVERAGE DAILY ENERGY SUPPLIED
to the load (Data View - Today Tab) is within design
parameter.
•
PERFORMANCE DATA EVENTS
. - Download performance data in the Performance Data Menu.
• SERVICE REQUIRED - Check the Attention Required box in the Data View - Now Tab. Right click this to
open the SP LINK manual which contains a list of messages and the actions required.
SERVICE
