INTRODUCTION | Warranty and manual use
6
|
Doc #OI0003 Part #004122 Rev19 2014
Australian/New Zealand Warranty
The Selectronic SP PRO product is warranted by the manufacturer to the original purchaser only. The
manufacturer will bear the cost of parts and labour to repair any faults found within the terms and period of
this warranty. For full warranty terms and conditions please see the warranty card packed with the SP PRO
inverter.
If you have purchased the SP PRO outside Australia or New Zealand, please see the separate warranty
supplied by the authorised distributor in your country.
Maximum warranty duration is given when the SP PRO is installed by a Selectronic Accredited Integrator
and warranty registration is carried out on-line at.
www.selectronic.com.au
Selectronic Australia shall be under no obligation to warrant any equipment which has been improperly
installed, stored, or handled, or which has not been operated or maintained according to this manual, nor
for any operating mistakes and consequences arising from them.
Using This Manual
While every attempt has been made to ensure this manual is as self explanatory and clear as possible,
there are some technical issues and safety warnings that require thorough understanding. It is extremely
important that the owner and integrator/installer follow all of the instructions set out in this document; failure
to do so may void the warranty and not give the full benefits that this product can provide.
This manual is divided into four sections to allow fast access to relevant information. The heading on each
page indicates the section.
INTRODUCTION
This section, which provides a brief overview of the SP PRO including information
about warranties and terms used in this manual.
INSTALLATION
Contains information relevant to the installers from unpacking the unit to configuring
the settings of the SP PRO using SP LINK interface software. Also see the SP LINK
manual (contained in the SP LINK software) for Configuration Settings and Monitoring
details
OPERATION
Information relevant to the user and covers the day to day operation of the SP PRO as
well as certain safety warnings. This section presumes the unit’s installation and set
up is complete and correct.
SERVICE
Provides information to service personnel in regards to preventative maintenance and
troubleshooting in case of a fault.
A PDF copy of this manual may be downloaded from the Selectronic web site
www.selectronic.com.au
and
is also included within the Help menu of the SP LINK software.
Throughout the manual the following symbols will be repeated. These symbols are very important.
This symbol indicates danger. Failure to observe this warning may result in serious injury or
death, loss of property or damage to the power system
This symbol is used to draw attention to information that will assist in making full use of the
system or gives notice to information which may not seem immediately apparent
