17
Fit a joining sleeve into the next 2400 mm
(94 1/2”) extrusion together with a connecting plate. Connect this to the lower extrusions.
Using a spare joining sleeve, push in the distance tube from the top until the lower joining sleeve
touches the distance tube below the join. Check that the distance (J) between the end of the
distance tube and the end of the extrusion is approximately half the length of a joining sleeve.
Connect the remaining extrusions according to
”Table 2”
(3.6.1).
Fit the halyard swivel over the top end of the extrusion, slide it down as far as the sail feeder and
secure it in this position with adhesive tape. Fit the top guard and secure it with the four pre-fitted
screws. Tighten the screws until they bottom, but do not over-tighten.
Guide the lower bearing assembly on from below. Push it carefully onto the extrusion so that the
stainless steel inner tube does not scratch the extrusion. Use cloth or paper for protection.
5.
6.
7.
8.
Fig. 4.1.e
Fig. 4.1.f
Fig. 4.1.h
J
Fig. 4.1.g
400 S
Fig. 4.1.g
500 S
