10.9) Control panel PC board 15.22.131 (15.14.259 PC board + FP131)
This board performs the following functions:
- microprocessor control of all the machine
- air pressure control (board-mounted pressure switch)
CAUTION!
- PZ2 must always be electrically connected to protection earth!
Dip-switch (factory setted):
DS1 G90
1
OFF
2
OFF
3
OFF
4
ON
NOTE:
dip switch 3 being ON allows bypassing the alarm generated by the pressure switch in the event of air pressure being
non-existent or lower than 3 bar; this operating mode can make testing the machine during diagnostics or repairs easier.
Before the final cutting test set dip switch 3 OFF again.
Unless specified otherwise, all the measurements must be taken with the boards fitted, together with their connections!
40
Description, testing and replacement of the electronic boards, current calibration
Summary of Contents for Genesis 90
