Selco Genesis 284 PSR, Instruction Manual

Page: 42 / 304

42
7 Warning limits line
8 Alarm limits line
9 Minimum levels column
10 Maximum levels column
Select the required box by pressing the encoder key (the select-
ed box is displayed with reverse contrast).
Adjust the level of the selected limit by rotating the encoder.
Save and exit the current screen by pressing button (3) .
Passing one of the warning limits causes a visual signal to appear
on the control panel.
Passing one of the alarm limits causes a visual signal to appear
on the control panel and the immediate blockage of the weld-
ing operations.
It is possible to set start and end of welding filters to prevent
error signals during the striking and extinction of the arc (consult
the “Set up” section - Parameters 38 and 39).
3.14 Alarms screen
Allows the intervention of an alarm to be indicated and provides
the most important indications for the solution of any problem
encountered.
1 Alarm icon
2 Alarm code
3 Alarm type
Alarm codes
E00 General alarm
E01 Temperature alarm
E04 Communication alarm (PSR)
E05 Current too high alarm
E07 Wire feed motor supply alarm
E08 Blocked motor alarm
E10 Power module alarm
E11 System configuration alarm
E12 Communication alarm (WF - PSR)
E13 Communication alarm (RC 300 - PSR)
E14 Program not valid alarm
E16 Communication alarm (RI)
E20 Memory fault alarm (PSR)
E21 Data loss alarm (PSR)
E22 LCD display alarm
E23 Memory fault alarm (RC)
E24 Data loss alarm (RC)
E25 Memory fault alarm (WF)
E26 Data loss alarm (WF)
E40 System power supply alarm
E41 Overvoltage alarm
E42 Undervoltage alarm
E43 Coolant shortage alarm
E44 Gas shortage alarm
E49 Emergency switch alarm
E51 Unsupported settings alarm
E52 Anti-collision alarm