Selco Genesis 284 PSR, Instruction Manual

Page: 36 / 304

36
3b Allows the selection of the welding process
MMA
ARC AIR
TIG
3c Allows the selection of the welding method
2 Step
4 Step
Bilevel
Spot welding
Automation and robotics
3d
CONSTANT current
PULSED current
Fast Pulse
3.7 Quick choice menu
Allows the selection and regulation of the most commonly used
welding parameters.
Enter the quick choice menu by pressing button (1) .
Select the required parameter by rotating the encoder to bring
it within the central quadrant (2).
The value and the unit of measurement of the selected param-
eter are shown alongside (3).
Activate the regulation of the selected parameter by pressing the
encoder button.
3a Parameter selection bars
Adjust the value of the selected parameter by rotating the
encoder.
Confirm the change made by pressing the encoder button.
Exit the quick choice menu by pressing button (1).
PROCESS QUICK CHOICE MENU
MMA
ARC AIR
TIG
The parameters of the quick choice menu can be personalised
(consult the “Interface personalisation” section).
The activation of functions different from the default ones
changes the number and the type of parameters in the quick
choice menu.
3.8 Set up
Permits set up and adjustment of a series of additional param-
eters for improved and more accurate control of the welding
system.
The parameters present at set up are organised in relation to the
welding process selected and have a numerical code.
Entry to set up: by pressing the encoder key for 5 sec. (the
central zero on the 7-segment display confirms entry).
Selection and adjustment of the required parameter: by
turning the encoder until displaying the numerical code relating
to that parameter. If the encoder key is pressed at this point,
the value set for the parameter selected can be displayed and
adjusted.
Exit from set up: to quit the "adjustment" section, press the
encoder again.
To exit the set up, go to parameter "O" (save and quit) and press
the encoder.
List of set up parameters (MMA - ARC AIR)
0 Save and quit
Allows you to save the changes and exit the set up.
1 Reset
Allows you to reset all the parameters to the default
values.
2 Welding current
Permits adjustment of the welding current.
Parameter set in Amps (A).
Minimum 6A, Maximum Imax, Default 100A