7
Now install the Center Retainer on the inside of the
windshield using 2 - M6x30 Button Head Bolts and 2 -
M6 Nylon Lock Nuts.
14
Now attach each Hinge Half, Lower to the outer side
of the windshield with the angle coming away from the
polycarbonate. Fasten loosely with 4 – M8x16mm
Button Head Bolts and 4 – M8 Nylon Insert Lock Nuts.
The bolt heads should be on the metal side and the
nuts on the inside of the windshield
12
17
13
Remove the two bolts holding the buckle on from the
outside. Use two M8x50 Button Head Bolts and two
M8 Nylon Lock Nuts to attach the Strike Plate. Once
in place use a 5mm hex key to tighten the bolt from
the inside and use a 13mm wrench or socket wrench
to fasten the M8 Nylon Lock Nut from the buckle side.
Make sure the Strike Plate stays aligned as shown.
Repeat for the other side.
Shown is the Strike Plate, Passenger Orient the part
as shown.
16
15
15
15
