Place the Tube assembly on the inside of the
windshield with the pockets for captive nuts in each of
the mounting blocks facing upwards.
Insert two M6x45 Button Head Bolts through the
Badge (7), through the windshield, and then through
the Brace Mounting Block. Put the outer two M6
Nylon Lock Nuts in their captive pockets to fasten
until just a few threads engage. At this point just
tighten by hand or finger-tight using a 4mm Allen
wrench.
Use a M6x40mm Button Head Bolt and a M6 Nylon
Lock Nut to repeat this process for each Small
Mounting Block.
The hole alignment of the mounting
blocks to the holes in the windshield can be adjusted
at any time by rotating the tube within the mounting
blocks. Because of this, it is important to leave all
fasteners loose during steps 6-9.
Check the alignment on the End Mounting Blocks and
rotate the tube if needed. Now gently flex the
windshield towards the tube so that you can insert a
M6x50 Button Head Bolt through the other side of the
windshield, through the bottom hole of the Ball
Bracket, and then through the End Mounting Block.
Use an M6 Nylon Lock Nut in the captive pocket to
fasten the bolt. Only engage about 2-3 threads.
Repeat for other side.
5
6
7
8
7
5
..
