Segway S301000-20100A, Service Manual

Page: 41 / 407

2 - 26
MAINTENANCE
components with the new belt installed on the engine,
and tighten the bolts to the specifi ed torque.
7. Turn the driven wheel component counterclockwise
until the CVT belt is fully tightened.
8. Install the CVT cover and tighten the fi xing bolts.
The CVT dry
In some cases, the water may soak into the CVT system
and dry it before driving.
1. Remove the clutch drain plug.
2. Wait for the water to drain out and reinstall the water
drain plug.
3. Place the transmission in "P" gear and pull up the
parking handle.
4. Start the engine.
5. Lightly step on the accelerator pedal to increase the
engine speed and maintain it for 10-15 seconds to
expel moisture and air, and dry the belt and CVT. It is
strictly forbidden to fully open the throttle.
6. Allow engine speed to be kept at idle speed.Use the
brake.Convert transmission to the lowest available
range.
7. Belt skid test.If the belt slides, repeat the process.
8. Your segway dealer can help if your vehicle needs
service.
Drive Shaft Boot Inspection
Inspect the front and rear drive shaft boots for damage,
tears, wear or leaking grease. If the boots exhibit any of
these symptoms, they should be replaced. Check to see
the boot clamps are properly positioned. Refer to Chapter
7 for drive shaft boot replacement.
!
Do not lubricate the stud or the lug nut.