137
ERROR MESSAGE
17
ERROR MESSAGE
The following messages may appear upon turning on the power or leaving TEST MODE. Under these circumstances
the game cannot be played. The error codes are roughly divided as follows.
Error Code
Category
Error 01 - 09
An error relating to the actual hardware or setup of the title program.
Error 10 - 19
An error relating to something dependant upon the title program, such as JVS or
the Firmware version.
Error 20 - 29
(Not used)
Error 30 - 39
An error relating to the Ether-network.
Error 40 - 49
(Not used)
Caution 50 - 59
A warning related to set-up settings.
MESSAGE
ERROR 01
THIS GAME IS NOT ACCEPTABLE BY MAIN BOARD.
CAUSE
1) The title program in the flash memory on the SystemSP board is corrupted.
2) The Key Chip may not match the title program on the SystemSP board.
COUNTERMEASURES
1) If you have a CF memory including renewal data for the title program, insert
that CF memory and then restart the machine.
2) Insert the correct Key Chip and then restart the machine.
If the problem remains it is most likely a problem with the board itself. Refer
to "16-3 Removing the Game Board" to remove the SystemSP board and repair
it along with the Key Chip.
MESSAGE
ERROR 03
BAD SERIAL NUMBER ON MAIN BOARD.
CAUSE
The SystemSP board’s serial number is incorrect.
COUNTERMEASURES
This is a problem with the SystemSP board. Refer to "16-3 Removing the Game
Board" to remove the SystemSP board and repair it along with the Key Chip.
MESSAGE
ERROR 05
THIS GAME IS NOT ACCEPTABLE BY MAIN BOARD.
CAUSE
The SystemSP board set-up does not match with the set-up required by the title
program.
COUNTERMEASURES
The game cannot be used with the SystemSP board. Use the SystemSP board with
the correct set-up.
17
Summary of Contents for TETRIS GIANT
