18
ASSEMBL
Y AND
INST
ALLA
TION
6
6
• For the sake of safety, use the main power cords provided. If a main power
cord is damaged, it must be replaced by the manufacturer, a recognised
distributor or a qualified engineer to avoid any hazard.
• When inserting or removing a connector, always hold it by its main part. If you
hold it by anything else while doing so, the connections between wire and
connector terminal fixtures could be damaged; and there could be a short
circuit or fire. There could also be poor connectivity.
•
Make sure that all the adjusters are resting on the floor. The cabinet may move
and cause an accident if the adjusters are not laid out properly.
• Whenever any fasteners (e.g. screws, nuts) have been lost, always use
replacement fasteners with proper dimensions as specified in this manual. If
fasteners of any other dimensions are used, it could cause damage and/or
separation of parts that result in secondary accidents.
• Be careful when aligning, attaching or mounting parts so that your head,
hands, fingers, etc., do not get caught in anything. If two or more workers
are working at the same time, exercise special caution. Failure to be
cautious could result in accidental bone fractures or amputation. Check the
surroundings carefully before proceeding.
• When connecting wires inside the cabinet, there may be instances in which the
indoor lighting does not reach that location. Have a flashlight or other auxiliary
lighting equipment on hand. If wires are connected carelessly, there could be
an accidental short circuit, fire, etc.
• When tightening bolts and screws, ensure that other parts are suspended
properly and bolts and screws are fastened tightly. Be sure to take accident
prevention measures such as having another worker support parts. If a part
drops or topples over during this work, a serious accident may result.
• Support and hold parts in place securely and fasten them with screws and/or
bolts. Use two workers, one to support the part and another to fasten it in place.
If a part is not supported securely, it might fall down, resulting in an accident.
•
Wear appropriate work clothing so that work can be performed safely. Use
gloves and safety shoes to prevent accidents or injuries.
• When installing a wire protection cover over a floor, use a material shaped
so that no one passing by will stumble over it. Using a material that could be
stumbled over might lead to an accidental fall.
• Be careful in handling plastic parts. Be sure not to tighten screws or nuts
too tightly. If such parts are exposed to excessive loads or impact, they
might become damaged, resulting in fragments or cracks that could cause
accidental injury.
Summary of Contents for MISSION IMPOSSIBLE ARCADE
