35
Ausgabe
issue
D / 04.02.2013
Dokument
document
OM.SCT.02e
Blatt
sheet
13 (18)
9
Dismantling/reassembly
9.1.4.3 Rotating unit (RTE) - Reassembly
with flush connection
9.1.4.4 Segment retainer (671), suction casing (500) - pre-assembly
9.1.4.5 Suction casing (500) - Reassembly
Push on the shaft seal (SEA).
–
Note shaft seal reassembly. See
chapter 9.4 of the operating and as-
sembly instructions.
Coat the splash ring (310)/plug-in shaft
(307) with pin joint grease.
Push the splash ring (310) onto the plug-in
shaft (307).
–
Observe the fitting position of the
splash ring (splash ring marking).
Apply antiseize graphite petroleum to the
drive unit's (ANT) drive shaft. Push on the
rotating unit (RTE).
Push in the plug-in shaft pin (309).
Install the splash ring collar at a distance of
0.5 mm from the lantern (200).
Mount the flush connection.
Remove contaminants such as paint and
corrosion from all seal faces/centring re-
cesses (ZA).
Coat O-ring (731) with soft soap.
Insert the O-ring (731) into the centring re-
cess on the suction casing (ZA, 500).
Assemble the segment retainer (671) on
the suction casing (500) and align it using
a spirit level (W).
Provide rotor (600) with protective cover
(SH).
Prop up rotor (600) with support (S).
Slide on casing gasket (501).
Mount pre-assembled suction casing
(500) and adjust (using spirit level).
