Step 5 — Wifi Setup - Windows
Plug the micro USB cable into the USB slot on the (top) left side of your printer.
Connect to the printer with YAT, S3D, MatterControl, or carrier pigeon. Note that you'll need to set
the baud rate to 115200 in order to connect. Then send the following commands:
M552 S0
M587 S"yourssid" P"yourpass"
M552 S1
After sending M552 S1 , you should see a confirmation, and the IP address of your printer. Write
the IP address down, you'll use it in the next steps
Make sure your printer is close to your Wifi Router. If you a getting a lot of AJAX disconnected
errors, it's probably because the printer can't talk to your wifi reliably. Keep the distance between
them to a minimum.
The SD card can become partially unseated in shipping. It is highly recommended to remove it
(push it in until you hear the click, then it'll come out) and put it back in (push until you hear the
click) before you get too far into the setup.
Configuring Artemis
© 2018
seemecnc.dozuki.com/
Page 5 of 11
