Step 1 — Close Other APPs
Close other applications that may
use the USB com port.
This printer is NOT designed to run
from the USB port. Only connect the
USB cable during setup of the
printer.
The printer is designed to run from
either (a) browser window over your
intranet or (b) by addition of
touchscreen with SD card reader
Close Cura, Mattercontrol, or other
slicers you may have open.
Close any non-3D related programs,
like Arduino or other programs that
may use the USB com port.
Step 2 — STOP! READ THIS STEP
If you purchased a fully assembled printer, an RTP (ready to print) model, DO NOT install or
update new firmware. Your new printer is ready to use. Follow steps to configure the WiFi
connection, then proceed to the last step of this guide to get started with the slicing software.
Configuring Artemis
© 2018
seemecnc.dozuki.com/
Page 2 of 11
