8
|
CONVERSION INSTRUCTIONS
ASSEMBLY OF COOLER TO TANK
Lift the cooler onto the MobileMAX tank in the correct
orientation with the rectangular cutout opening in the
cooler aligned with the moulded opening in the tank and
with the service cord located in the recess at the edge of
the tank.
ILL2756-A
Cut the cable tie temporarily securing the pump (as
instructed on Pg 5).
Using the new extension hose from the kit, connect the
short elbow end to the pump and the other end to the 4
way connector, ensuring there is a loop in the hose.
Secure the 4 way connector to the scroll using one of
the screws which was previously used to secure the
pump to the tank. This will require drilling an appropriate
3mm (1/8”) hole in the scroll for the screw if using hand
screwdriver. If using a cordless or power driver, a pilot
hole may be required.
ENSURE THE FLOATING PLATFORM LOCATES IN PIVOT
POINTS IN TANK.
Using the pre-drilled rivet holes in the cooler as a guide
(Refer Fig. 2, Page 6),
drill down and through the tank
(12 places) with the 5mm drill.
Rivet the cooler to the tank
with the rivets supplied.
Clean out
any loose drilling material from inside the
cooler and tank with the vacuum cleaner.
Attach the pump to the mount bracket on the floating
platform using 1 x 20mm philips head screw. The pump
outlet is facing the air outlet panel.
ILL2762-A
ILL2757-A
Summary of Contents for MobileMAX Series
Page 15: ...DRILLING TEMPLATE INFORMATION ...