Seeley MobileMAX Series, Conversion Manual, Page: 10 / 16

10 |
MOUNTING THE CONTROLS
The MagIQtouch Switch Plate control that came with
cooler needs to be mounted to the upper right of the
grille. NOTE: All work involving the wiring of the controls
and service cord will need to be carried out by a qualified
electrician or service technician.
ON ON
OFF OFF
COOL SPEED
INTERNATIONAL
AIR
ILL2141-A
Using the backing plate of the controls as a template, drill
3mm (1/8”) fastening holes in the front panel.
Ensure the plate is square to the cooler lid. Using the
20mm (3/4”) spade bit, drill a cable access hole in the
front panel, in a place where it will be covered by the
control panel once fitted.
ILL2756-A
CONVERSION INSTRUCTIONS
WIRING THE COOLER CONTROLS
Plug the 1.5m communications cable supplied in the
MobileMAX Tank kit into the CPMD control box which
is inside the cooler. Lift the rubber splash cover on the
CPMD Control Box and plug in the communications cable
to the top “A” socket in the CPMD Control Box.
EVAP COOLER
100m ma
x
ON ON
OFF OFF
COOL SPEED
INTERNATIONAL
AIR
ILL2139-A
Fasten the Switch Plate to the backing plate using the
screws provided.
Coil any excess communications cable and tie above
the waterline using cable ties supplied in the MobileMAX
Tank kit.
ILL2768-A
Mount the backing plate using the screws provided.
Tighten the cable gland around the communications
cable to prevent moisture ingress to the controller PCBA.
Pass the 1.5m communications cable out through the
cable access hole/gland in the front panel from inside the
cooler and connect the wiring to the switch plate.
ILL2936-A
Fasten the cable gland supplied in the MobileMAX Tank
kit into the 20mm (3/4”) hole drilled into the panel. (Note
the orientation of the gland in the diagram below).