MAGIQ TOUCH CONTROLLER INSTALLATION MANUAL
|
1
CABLE LENGTHS
1
MOUNTING THE CONTROLLER
2
CONNECTING THE CONTROLLER
8
SINGLE COMPONENT INSTALLATION (NO ZONES)
8
MULTIPLE COMPONENT INSTALLATIONS
10
OPERATION SCREENS
11
SETTINGS MENU
13
GENERAL MENU
15
COOLER & HEATER MENUS
15
SERVICE MENU
16
CONTROLLER OR SYSTEM RESET
19
MANAGING COMPONENTS
20
ADDING COMPONENTS
20
REPLACING COMPONENTS
21
REMOVING COMPONENTS
22
MANAGING THE CONTROLLER
24
CONNECTING A NEW CONTROLLER
TO AN EXISTING SYSTEM
24
CONNECTING A PRE-USED CONTROLLER
25
FAULT ROUTINE
26
POWER OUTAGES
28
TROUBLE SHOOTING
29
TABLE OF CONTENTS
•
Cables used for the MagIQ Touch Controller
are 26AWG, 7/016, 6 core flat.
•
20m/66
"
cable is supplied with each Seeley cooler or heater
•
40m/131
"
cable is also available
• Supplied cables should not be altered.
ALWAYS route cables at least 300mm / 12
"
away from regular
power cables and high power machines. Cross over power cables
at right angles.
Important!
Where maximum cable lengths are exceeded, or cables are not
routed in accordance with our recommendations Seeley technical
support is not available and the product warranty may be voided.
Note!
The term “component” (Seeley International cooler or heater)
will be used in this document to describe any separate device,
such as a cooler, heater or sensor, which is to be connected
to the MagIQ Touch Controller.
CABLE LENGTHS
40m / 131"
MAX
ILL1583-A
Seeley International
cooler or heater
