2
|
MAGIQ TOUCH CONTROLLER INSTALLATION MANUAL
|
3
The Controller should be placed approximately 1.5 metres above
the floor, in the most used room of the home.
Placement is critical for correct functioning of the temperature
sensing thermostat inside the controller.
The following points must be taken into consideration:
• Avoid direct sunlight exposure.
• Avoid mounting on external walls.
•
Avoid mounting the wall control near heat sources such as
stoves and televisions.
• Do not locate in the direct airflow of the duct outlets.
•
Do not locate in strong drafts or in dead spots such as
cupboards/drawers.
• Always seal the cable entry hole. Hot or cold air coming through
the wall may interfere with the temperature measurement.
CAUTION!
Always make sure there are no electrical cables, gas or
water pipes, or the like, behind where you intend to drill.
MOUNTING THE CONTROLLER
Remove the mounting bracket from the rear of the Controller.
MOUNTING THE CONTROLLER
cont
STEP 1
STEP 2
STEP 3
ILL1584-A
ILL1585-A
ILL1586-A
