23
9.7 Push Blocks and Push Sticks
When planing smaller workpieces always use a push stick or push block.
In some operations push blocks should be used, especially when planing short or narrow pieces
of timber where it is necessary to pass the workpiece between the edge of the bridge guard and
fence. They should be constructed so as to give the machinist a firm grip and so reduce the risk
of his hands coming into contact with the cutters. A push block will reduce the risk of a short
workpiece dipping as it passes the lip of the feed table, thus making such abrupt contact with
the cutters that a throwback will be almost inevitable. Alternatively, consider planing a longer
piece of timber and cutting off the required length.
Handle doweled and glued to
pushstick therefore no metal
contact possible with the
cutters.
Hardwood
strip
housed and glued to body of
pushblock
Narrow pushblock for short
narrow thin material
Abrasive paper glued to base
to give better frictional grip
and prevent the workpiece
moving sideways
10.0 Thicknessing
Raising or lowering the thicknessing bed alters the depth of cut. Use the Thicknessing Table Rise
and Fall Handwheel and read off the thicknessing depth scale. Remember to lock the table in
position once the depth is set. Never try to remove too much at one pass.
3mm should be the
maximum.
Summary of Contents for PT255
Page 36: ...36 14 0 PT255 Planer Thicknesser Parts Diagram ...
Page 39: ...39 ...
Page 40: ...40 ...