JPEG2000 DVR User Guide
-46-
[CONNECTION SETUP]
Use
(( to select and [+] [-] or the Jog Shuttle to change the value.
1.[TIMEOUT]
Set up the remote connection a response time. If the client does not
receive responses from the DVR for a certain duration, the client will
disconnect the connection and try again. The setup range is from 1
millisecond to 12,750 seconds.
2.[RETRY COUNT]
Set up the number of times that the client tries to reconnect to the DVR.
The client will quit trying to reconnect to the DVR after all of the
attempts fail. The setup range is from 0 to 20 attempts.
[DHCP SETUP ]
1.[DHCP MODE]
Press ENTER to switch DHCP to [AUTOMATIC].
2.[DETECT IP]
Move the cursor to DETECT IP and press ENTER to start. Press MENU to
cancel the detection.
4-6-2 RS232C setup
Through the RS232 port, users can connect the DVR to a PC or other control
devices to control the DVR. The ASCII-Code information is in
CH.2, Serial port
setup
. Users cannot change the modem value in this setting.
1.[SPEED]
The transmission baud rate is 19,200bps.
2.[LENGTH]
The transmission length is 8 bits.
3.[STOP BIT]
The stop bit is 1.
4.[PARITY]
The parity is none.
