Security Command XR500 Series, User Manual

Page: 22 / 76

16 XR500/XR100 User’s Guide Arming and Disarming XR500/XR100 User’s Guide 17 Arming and Disarming
Checking the Armed Areas
After you have armed the system, you may press any Select key
to check the armed areas when ALL SYSTEM ON or SYSTEM ON
displays. The keypad then displays CHK ARMED AREAS: NAME NBR
LIST.
Select NAME to list all of the armed areas by name. Select NBR to
enter the area number you would like to check. Select LIST to list
all of the armed areas by number.
Area System Disarming Operation
While the system is armed, you can only enter the premises
through an entry/exit delay door without causing an alarm. After
opening the door, the keypad sounds a prewarn tone to remind
you to disarm the system. You must disarm the system before the
entry delay time expires or an alarm on the door zone occurs.
During the entry delay time, the keypad displays ENTER CODE: and
the name of the zone causing the entry delay. Enter your code
to disarm the system. Only those areas assigned to your code
disarms.
Note : Your system may be pre-programmed so that the prewarn
tone may silence as soon as the first user code digit key is pressed.
If a valid user code is not entered or an invalid user code is entered
within five seconds, the prewarn tone begins sounding again.
Schedules:
If you have programmed schedules for your system and
a code is entered outside of a schedule and that code does not have
authorization to disarm outside of schedules, the keypad displays
INVALID TIME. This lets users know that they are attempting to
disarm outside of their authorized time.
All or Selective Disarming: After entering your user code, the
system allows you to disarm either all of the areas to which you
have access or just selected areas. If you choose to disarm all
areas, the system automatically disarms them. If you choose to
disarm selected areas, the area names display on the keypad.
Alarm Display:
After disarming, the keypad displays any zones
that tripped or any transmission problems that occurred during
the armed period. All burglary zones are then disarmed and any
bypassed zones are automatically reset.
Disarmed Message: The keypad displays ALL SYSTEM OFF after the
system disarms.
Central Station Report:
Your system may be pre-programmed at
installation to transmit a system disarming report to the central
station.
Door Access Disarming: Your system may be programmed to allow
area disarming when a card is presented to a door access reader
located outside of the building. Simply present your card to the
reader and after the card code is validated for the appropriate
authority, a door access is granted and your matching areas are
automatically disarmed. See the Easy Entry™ User’s Guide in
Appendix E.