SafeLogic Xtreme Installation and Operation Instructions
Doc. No. XU-EC1501A-X151123
SecuRam Systems Inc.
Page 13
9.1 First SpinDial Combination Opening
Step 1: Pull up on the SpinDial Release to disengage the electronics
Step 2: Now rotate the SpinDial 4 full revolutions to the left (or counter clockwise) stop when
you see 50 at the Dialing Index the fourth time. (The Dialing Index is the small red arrow pointing
to the numbers in the center of the SpinDial Release as shown below)
Step 3: Now rotate the SpinDial to the right until it comes to a stop (within one revolution)
When the SpinDial comes to a stop the lock is open.
Step 4: Turn your safe handle.
Since all combination numbers are set to “50”, we did not need to dial the other numbers in the
combination, since they were already aligned correctly allowing the lock to open.
Note: If the lock does not open on 50, try dialing the combination again but this time to 49 or 51.
The lock will open on 49 or 51, because the DialRing may not be in perfect vertical alignment with the
lock body.
It is important to remember the combination on which the lock opened, as we will use this number
in our change combination process.
9.2 Changing the Mechanical Combination
Step 1: Write down the number that the lock opened on the first time – for this example we will
assume the mechanical combination is 50 (but perhaps it opened on 49 or 51).
