SafeLogic Xtreme Installation and Operation Instructions
Doc. No. XU-EC1501A-X151123
SecuRam Systems Inc.
Page 4
The mounting hole at the bottom of the DialRing is covered by the rotating dial. First pull
up on the Spin Dial Release then turn the dial to expose the mounting hole and install
the DialRing Mounting bolt (Part# M4 Bolt).
Note: In most safe installations, there are only two DialRing mounting holes, either aligned
vertically or horizontally. Two bolts are adequate to secure the DialRing in place.
Step 7: Tighten the DialRing Mounting bolts (Part# M4 Bolt) to hold the DialRing in place. It is not
necessary to securely tighten the Dial Ring Mounting bolts (Part# M4 Bolt), as the
installation of the DialRing shall be adjusted during the next steps.
Step 8: Cut the supplied clear plastic spindle tube (Part# TB-9/80-P) to a length equal to Door
Thickness, where the Door Thickness or “DT” is the measurement from the Safe door
outer surface (the surface upon which the DialRing is to be mounted) to the lock body
mounting plate (the surface upon which the lock body is to be mounted).
3.0 Installing the Lock Body
Step 1: Gently pull on the 4-wire cable to ensure there is no excess cable in the spindle hole and
place the cable as shown.
Step 2: Insert the clear plastic spindle tube (Part# TB-9/80-P) into the spindle hole until it comes
into contact with the DialRing. It will be protruding into the safe approximately 3/8”
beyond the surface of the lock mounting plate.
