ENFORCER Voice Dialer
4
SECO-LARM U.S.A., Inc.
Overview:
LCD Screen Layout:
Front
Back (Covers Removed)
LCD Display
Speaker
REC/PLAY LED
LOW BATT LED
POWER LED
Numeric Keypad
Microphone
LINE Jack
TEL Jack
Buzzer
Terminal Block (with Trigger 3 Jumper)
DC Power Jack
Battery Receptacle
Reset Button
Note:
For explanation of symbols, please see
Programming the Voice Dialer
on pages 6~9.
Installing the Voice Dialer:
Siren Alarm
Auto Dial
Call-Back Rings
Home Mode
Activated
Alarm Triggered
Time/Date
PASSWORD
PASSWORD
PASSWORD
PASSWORD
MEMORY
MEMORY
MEMORY
MEMORY
LEARN
LEARN
LEARN
LEARN
℡
℡
℡
℡
CYCLE
CYCLE
CYCLE
CYCLE
ENTRY
ENTRY
ENTRY
ENTRY
2015
2015
2015
2015-
-
-
-01
01
01
01-
-
-
-01 12
01 12
01 12
01 12-
-
-
-00
00
00
00
ARM
ARM
ARM
ARM
TRIGGER HOME
TRIGGER HOME
TRIGGER HOME
TRIGGER HOME
Armed or
Disarmed
Note:
You can program the telephone numbers and voice messages prior to connecting the power
as long as the 9V battery is installed. The standby battery should provide about 20 hours of
operation.
Note:
The Voice Dialer uses EEPROM to retain memory in the event of a power loss.
ENFORCER Voice Dialer
SECO-LARM U.S.A., Inc.
13
Operating the Voice Dialer, continued:
Home Mode Use
To turn off the alarm function and use the dialer as a door chime, set the dialer to “Home” mode. A
chime will ring any time one of the sensors is triggered.
To activate the “Home” mode:
1.
Press the [HOME] button once. One chime will sound and the word ‘HOME’ will appear on the
LCD screen.
2.
After 60 seconds, another chime indicates that the voice dialer is now in the “Home” mode.
3.
When a sensor is activated, the voice dialer will chime twice.
4.
If the panic button is pressed, the voice dialer will sound a 30-second alarm and start the
dialing sequence to the programmed emergency numbers.
To deactivate the “Home” mode, simply press the [HOME] button.
Note:
Arming the system deactivates the “Home” mode. After disarming, reactivate the
“Home” mode if desired.
Low-Battery (LOW BATT.) Indicator
When the charge level of the 9VDC backup battery (not included) is low, the “LOW BATT.” LED
will flash once every 1.5 seconds. Replace the battery in order to continue providing functionality
during a temporary disruption in power.
Note:
In order to avoid potential damage due to battery leakage, do not leave a low battery in
the unit. Also, be sure to remove the battery if the unit is unused for a period of time.
View Function
To view the last 5 sensor trigger events, while in standby mode press the [#/DOWN] button.
To view stored emergency telephone numbers, while in standby mode press the [*/UP] button.
Note:
After 10 seconds of inactivity, the voice dialer will automatically exit the view mode and
return to standby.
Tips:
1.
Make sure that the full telephone numbers have been stored as they would normally be dialed
from a local phone.
2.
The voice dialer is only suitable for single phone lines. It is not compatible with fax machines.
3.
Set the number of Call-in rings to be less than the voicemail or message answer point.
