Initial operation of machine and software
Caution! Please note that the smooth installation and complete configuration requires
DrawCut PRO to be installed first.
Installation DrawCut PRO
Your Secabo flatbed vinyl cutter is delivered with the cutting software DrawCut PRO. This software
needs to be activated over the Internet. You do not necessarily need internet access on the
computer, on which DrawCut will be installed. The activation can also be done on another
computer.
In order to control your flatbed vinyl cutter via your computer, install the software as follows:
● Disable the Windows Firewall and your anti-virus software for the time of installation.
● Download the current version of DrawCut PRO at http://www.draw-cut.com/#downloads
and follow the installation wizard.
● Find your 26-digit DrawCut serial number on the printout that was delivered with your
flatbed vinyl cutter. Enter it when you are prompted to do so.
● Now you can use DrawCut PRO.
Installation of your Secabo flatbed vinyl cutter in DrawCut
Please keep in mind that your Secabo flatbed vinyl cutter can only be operated under Windows 7,
8, 8.1 and 10. Operation with an older version of Windows is not possible.
● First, make sure that your PC is connected to the internet.
● Connect the flatbed vinyl cutter to your computer using the supplied USB cable.
● Switch on the device.
● Your Secabo flatbed vinyl cutter will now be recognized. Windows will search for the
appropriate drivers and automatically install them. This can take some time. After that, the
device is ready for operation.
● Start DrawCut.
● First, open the "Vinyl Spooler" in Drawcut.
Secabo GmbH | Hochstatt 6-8 | 85283 Wolnzach | Germany | [email protected] | www.secabo.com
7
