● Place your printout in the vinyl cutter as seen in the screenshot below. Top or bottom first
doesn't matter, because the software will detect the direction the printout was insert when
reading the bar code. Activate the laser on the flatbed vinyl cutter by pressing the F3 key.
Position the vinyl cutter's laser analogous to the red dot in the screenshot below and use
the Enter key to set it as origin. Make sure that "Use multiple tools" is disabled in the cutter
settings. Next, simply start the contour cut by clicking on "Start"
With two tools
Secabo GmbH | Hochstatt 6-8 | 85283 Wolnzach | Germany | [email protected] | www.secabo.com
21
