Installing and adjusting the knife and creasing tool
● Take the supplied cutting knife, open the knife holder by turning the silver knurled screw
and insert the blade into the knife holder. Close the knife holder in the reverse order
● Now adjust the cutting depth by turning the silver knurled screw at the top of the knife
holder.
● Initially, the depth is set correctly if you can carefully move your fingertip across the blade
and merely feel a light scratching. Since the depth adjustment for the blade depends on the
material, it may be necessary to adjust it later.
● Secure the blade setting by tightening the gold lock nut.
● Press the pin on the rear end of the knife holder to clean the inserted knife of deposits and
residue. Caution - risk of injury!
● The various material thicknesses require different blade settings or even special blades; it
may therefore be necessary to repeat the adjustment described above.
● The length of the two creasing tools, on both sides of the creasing tool, can be adjusted
using the supplied hexagon socket wrench!
Inserting the blade holder
● First, sufficiently loosen the clamping screw for the blade holder (on the right side when
viewed from the front) at the cutting head.
● Next, press down the blade holder from above into the hole on the right side until there is
contact and pull the lock nut tight. When doing so, please ensure that the blade holder is
also secured correctly from above by means of the fixture provided for this purpose.
● Next, sufficiently loosen the clamping screw for the creasing tool holder on the cutting head.
● Proceed by pressing down the blade holder into the hole on the right side from above, until
there is contact, and tighten the clamping screw. When doing so, please ensure that the
creasing tool holder is also secured correctly from above by means of the fixture provided
for this purpose.
Inserting media
● First, move the cutter head to a position that ensures easy insertion of the material to be
cut. One shall avoid that the material to be cut gets pulled through beneath the cutter head.
● Activate the vacuum pump by pressing
F1
, so that the material to be cut adheres to the
work surface. Should the suction force be insufficient, it is advisable to cover the uncovered
areas of the working surface, for example, with paper or another type of medium.
● When inserting, make sure that the film is straight, especially when using crop marks.
Moving
the cutter head
To move the cutter head, first press the Off/Line key to switch to the offline mode, then use the
arrow keys to move the cutter head along the individual axes.
Secabo GmbH | Hochstatt 6-8 | 85283 Wolnzach | Germany | [email protected] | www.secabo.com
11
