SEBA KMT Sebalog GT-3-1, User Manual, Page: 41 / 47

GT-3-1 activities performed at the installation site
41
10 GT-3-1 activities performed at the installation site
10.1 Introduction
After performing the set-up tasks in the office, all other steps must be performed directly
at the usage site.
The following prerequisites must be met:
•
Laptop with SebaDataView-3 software.
•
Access rights for User level 1 if the software and the GT-3-1 are password
protected.
•
A wireless interface must be connected to the laptop (e.g. LOG RI).
•
The loggers must be switched off.
•
All GT-3-1 devices must be equipped with a SIM card.
•
All GT-3-1 devices should be switched off.
Note: The GT-3-1 and the loggers connected to it must be installed in one and the
same shaft. Otherwise, the radio connection between the devices might not
function properly.
You will find explanations of the individual worksteps in the following sections.
10.2 Switching the GT-3-1 on
Switch the GT-3-1 on by moving a magnet over the On/Off area , or ensure that it is
still switched on. The status LED flashes regularly when the device is switched on.
10.3 Adding loggers to the GT-3-1 group
You have already created a GT-3-1 group in the directory tree of the SebaDataView-3
software.
All loggers that are to be connected to the GT-3-1 must now be added to this group.
A maximum of three loggers per group is possible.
Open the SebaDataView-3 software on the laptop. If the access is password protected,
you must log in at User level 1 or 2. User level 3 only has reading rights.
Then proceed as follows:
Step Description
1 Mark the relevant group in the directory tree.
2 If you wish to register a N-3 noise
logger, open the
LogN3 tab in the menu
bar.
If you wish to register a P-3 pressure
logger, open the
LogP3 tab in the menu
bar.
3
Click
New
in the
Administration
segment.
Result:
The window for logger registration opens.
Requirements
Introduction
Procedure