12
OTHER OPTIONS:
- Selecting OUT AUX exict function.
- Programmig Radiococotrol Alarm for partial Activation /
Deactivation with exclusion of Zone 1.
- Functioning P input = AUX input.
- Selecting functioning info Flash Light.
_____________ EXTENDED MENU’ 1 _____________
LED Reference LED Off
LED On
A) CODE
OUT AUX = Monostable OUT AUX = Double-Stable or Temp.
B) CODE ALARM Code Alarm Part = OFF Code Alarm Part = ON
C) LAMP./CORT. P = Command Input
P = AUX Input
D) T. MOT.
Lamp Light = Info ON Lamp Light = Info Temp.
E) T. PAUSE.
Menù 1 = Mode Flashing 1110-1110-1110 ........
- P and T input= End-course CH e AP.
- P and T input= DOWN e UP buttons.
- Functioning dead man in Closing.
_____________ EXTENDED MENU’ 2 _____________
LED Reference LED Off
LED On
A) CODE
P e T = default
P = FC. CH e T = FC. AP
B) CODE ALARM P e T = default
P = UP e T = DOWN
C) LAMP./CORT. User present CH=OFF User present CH=ON
D) T. MOT.
Not Used
Not Used
E) T. PAUSA.
Menù 2 = Mode Flashing 1110-1110-1110 ........
- For futher information to the functioncs above visit
the web site www.seav.com
RESET:
To reset the default configuration of the control unit, press
the SEL and SET buttons simultaneously; all RED indicator
LEDs will switch on and then off again immediately.
INSTALLER ACTIVATION MODE:
In case of maintenance of the alarm system, it is neces-
sary to Activate the installer mode in order to deactive de
alarm system And the Tampere control input, if you wish
this mode, proceed as Follows: disconnect and reconnect
the 230 Vac supply line to the Unit, keeping pushing for at
least 10 seconds the memorized CODE ALARM Button of
the radio control, at the same time You get a short flash
of all the leds and the simultaneous Activation of Lamp
light output for 3 seconds, so the programming Is done.
Automatically the installer mode is deactivated at the First
cycle of normal functioning of frame or at the activation of
the Alarm system.
DIAGNOSTICS :
Command Input Test and Sensors:
In correspondence to each low voltage input command,
the control unit uses LED signals allowing rapid status
control.
Functioning logic: a lit LED means input closed, an unlit
LED means input open.
MANAGEMENT OF PROGRAMMING LEDS:
After 3 minutes of inactivity during the programming, the
unit Automatically turns off the programming leds for sav-
ing energy. With a pressure of SEL or SET buttons, or a
moving delivery Command, the LEDs will turn on, basing
on memorized Programming.
Rev. 3.0 13/06/2016
