Seat Alhambra 2019, Owner'S Manual

Page: 277 / 380

Driver assistance systems
the rear cross traffic alert are used negli-
gently or involuntarily. The system is not a
replacement for driver awareness.
● Adapt your speed and safe distance to
the vehicle in front of you at all times to suit
visibility, weather, road and traffic condi-
tions.
●
Keep your hands on the wheel at all times
to be ready to intervene in the steering at
any time.
●
Pay attention to the control lamps that
may come on in the external rear view mir-
rors and on the instrument panel, and fol-
low any instructions they may give.
● The blind spot assistant could react to
any special constructions that might be
present on the sides of the vehicle: e.g. high
or irregular dividers. This may cause erro-
neous warnings.
●
Never use the blind spot detector with
rear cross traffic alert on unpaved roads.
The blind spot detector with rear cross traf-
fic alert has been designed for use on
paved roads.
●
Always pay attention to the vehicle's sur-
roundings.
●
Never use the blind spot detector or the
parking assistant if the radar sensors are
dirty.
●
The external rear view mirror control
lamps may have limited functionality due
to solar radiation.
CAUTION
●
The radar sensors on the rear bumper
may be damaged or shifted in the event of
a collision, for example, when entering or
exiting a parking space. This may result in
the system disconnecting itself, or at least
possibly having its functionality diminished.
● In order to ensure that the radar sensors
work properly, keep the rear bumper free of
snow and ice and do not cover it.
●
The rear bumper should only be painted
with paint authorised by SEAT. The blind
spot detector's functions may be limited or
work incorrectly if other paints are used.
Note
If the blind spot detector with parking as-
sistant does not work as described in this
chapter, stop using it and contact a speci-
alised workshop.
Control lamps
Control lamp in external rear view mirrors:
 It lights up
It lights up once briefly: the blind spot detector is ac-
tivated and ready to operate.
It lights up: blind spot detector has detected a vehi-
cle in the blind spot.
 Flashes
The blind spot detector has detected a vehicle in the
blind spot and the turn signal has been turned on in
the direction of the detected vehicle
›››
.
For vehicles that are also equipped with Lane Assist
›››
page 272 , a warning to switch lanes will also ap-
pear even though the turn signal has not been en-
gaged.
The control lamps light up when the ignition is
switched on and should turn off after approxi-
mately 2 seconds. This is the time taken for
the function check.
If there are no indications from the control
lamp in the external rear view mirror, this
means that the blind spot detector has not
detected any other vehicles in the area
›››
.
If the dipped beam is on, then the control
lamps in the external rear view mirrors will be
dimmed (night mode).
WARNING
If the warning lamps and the corresponding
messages are ignored when they light up,
the vehicle may stall in traffic and cause
accidents and severe injuries.
●
Never ignore the warning lamps or mes-
sages.
●
Carry out the necessary operations.
»
275