3000LRS DGPS RECEIVER
OPERATOR’S MANUAL
A Product of the Fugro Group of Companies
Issue 2.00 JUNE 2003
B11203400PMBRA0 / 5
Fugro proprietary modes where raw messages sent over the satellite link are
made available to DGPS processing packages eg Fugro WADS, Seadiff, MN8
QC, MRDGPS.
3000LRS GETTING STARTED
3000LRS Front Display
3000LRS Rear Display
Initial Setup
1. Connecting the Power Lead
The 3000 unit will accept a DC voltage of 10-32v connected to the power socket
on the rear of the unit (item 1). The power lead supplied has a Kycon type
connector that has a push on – pull off function. This connector should be
pushed into position with the flat sprung loaded surround (which displays an
arrow) to the base of the 3000LRS unit.
2. Connecting the Antenna cable
The antenna cable supplied with the unit is terminated with a TNC type
connector. This should be screwed into the ‘DGPS ANT’ connector (item 2) on
the rear left hand side of the unit
3. Power On
To power on the unit switch the power switch (item 3) on the rear of the unit to
the ‘ON’ position.
On ‘power on’ the unit will instigate a boot-up sequence and the front panel
display will display the following indications:
2
3 1
