Seastar Solutions OPTIMUS EPS, Operation Instructions And Users Manual

Page: 7 / 56

© 2012 SeaStar Solutions Optimus Operations Manual, Rev. D
1-1
1.0 SAFETY INFORMATION
THE SAFETY INFORMATION PROVIDED BELOW IS INTENDED TO
INFORM YOU OF THE DANGERS THAT MAY BE PRESENT BEFORE,
DURING AND AFTER USE. IT IS CRITICAL THAT YOU READ AND
UNDERSTAND ALL THE POINTS NOTED.
Safe operation of the steering system depends upon proper installation
and maintenance of the system, and the common sense, safe judgment,
knowledge, and expertise of the operator. Every installer and operator
of the steering system should know the following requirements before
installing or operating the steering system.
If you have any questions regarding any of these warnings, contact
SeaStar Solutions.
Perform a system inspection as outlined below. Refer to Section 3.3
for further details.
1. Check steering fluid level in all steering pumps.
2. Verify immediate steering response when turning steering
wheel(s).
3. Inspect all steering hoses, fittings and mechanical and electrical
cables for wear, kinks, or leaks.
4. Check for binding, loose, worn or leaking steering or shift/throttle
control components.
5. Verify proper shift and throttle response for all control levers.
6. Verify that no alarms or warnings are shown on the CANtrak
display.
DO NOT OPERATE BOAT IF ANY COMPONENT IS NOT IN PROPER
WORKING CONDITION.
Prior to every use
To reduce the risk of severe injury or death:
1. Always wear a Coast Guard Approved personal flotation device
(PFD) and use an engine shut-off cord (lanyard).
2. Read and understand this User’s manual and the Quick Reference
Card provided with your vessel control components.
3. SeaStar and Optimus components are highly engineered and safety
tested to ensure system integrity. DO NOT substitute any component.
Substitution with non-SeaStar or non-Optimus components may
compromise system safety, performance, and reliability.
WARNING
WARNING
THE OPTIMUS EPS SYSTEM MUST ONLY BE INSTALLED BY AN
AUTHORIZED DEALER OR OEM.
WARNING