SEALINE S450, Owner'S Manual

Page: 47 / 97

86,1*<285%2$7
6HDOLQH2ZQHUV0DQXDO3DJH
Starting with the start/stop panel
Press the starter button for each engine. Release the
button as soon as the engine has started.
Read the instruments and warm the engine up
Allow the engines to idle for the first ten seconds.
Check that instruments and warning displays show
normal values.
Check that no messages are displayed and no
warning signs are showing.
Warm the engine up at low speed and low load, so
normal operating temperature is reached before full
power is used.
STOPPING THE ENGINES
Allow the engine to run at low idle, in neutral, for a
few minutes after operations are completed. In this
way after-boiling is avoided at the same time as
temperature equalization takes place. This is
especially important when the engine has been run at
high rpm or under heavy load.
IMPORTANT!
Never disconnect the current with the main switches
when the engine is running. The alternator and
electronics could be damaged.
Stopping with the e-Key panel
1 Disengage the drive/reverse gear by putting the
control lever in neutral.
2 Stop the engine(s) by pushing the
START/STOP button (s).
Stopping with the start/stop panel
1 Disengage the drive/reverse gear by putting the
control lever in neutral.
2 Push the stop button(s). Release the button(s)
when the engine(s) has/have stopped.
Turning the ignition off and locking the EVC system
To turn the ignition of, press the IGNITION button.
The green lamp in the IGNITION button goes out to
indicate the ignition is off.
To lock the EVC system, hold the key fob in front of
the symbol on the e-Key panel.
A flashing red light indicates the system is locked.
REFER TO THE ENGINE OPERATOR'S MANUAL
FOR MORE DETAILED INFORMATION
WARNING
To avoid serious engine damage, never race
the engine when it is cold.