Sealed Air Taski swingo 350B, Manual, Page: 76 / 390

74
Cleaning the fresh water tank
Cleaning the suction hose
Cleaning the fresh water tank filter
Removing and cleaning the brush
• Thoroughly rinse the recovery tank with clean water.
After the end of operation
1. Rinse the tank out well with water
Fill the solution tank with water. Push the machine to a
floor drain or a suitable location. Switch on the brush unit
and flush out the complete system with water.
Then completely drain the solution tank by screwing out
the filter.
Periodically
2. Cleaning with chlorine tablets
Completely fill the solution tank with clean water. Add
chlorine tablets according to the manufacturer's instruc
-
tions. Switch on the brush unit, and flush the complete
system with chlorine solution for approx. 30 secs. Then al
-
low the solution to work in the solution tank for 45-60 min
-
utes.
3. Work at end of operation
Drain out the chlorine solution by unscrewing the filter.
Then screw the filter into the filter housing. Half-fill the
solution tank with clean water. Switch on the brush unit,
and flush out the complete system with clean water. Rinse
out the solution tank well. Drain the residual water out of
the solution tank. Then screw the filter into the filter hous
-
ing. Leave the tank lid open and allow the solution tank to
dry out well.
Caution:
Do not add any detergent to the chlorine
solution. AOX can arise (absorbent organ
-
ic halogen compounds). These are haz
-
ardous to the environment and are
poisonous.
Attention:
Never add chlorine tablets to an acidic
solution (generation of chlorine gas). It is
imperative to train staff! Descale only
when needed, never use chlorine tablets
in addition!
Attention:
Store chlorine tablets at a safe distance
from acidic products. It is imperative to
train staff!
• Place the machine on the parking
support.
A: For traction batteries; use the
parking support on the right
B: For lithium-ion batteries; use the
parking support on the left
• Open the tank lid.
• Remove the recovery tank and squeegee.
A
B
• Pull the suction hose out of the hold
-
er into a vertical position.
• Clean the suction hose with running
water so that dirt is removed.
Notice:
Even though the suction hose is not
marked in yellow, it is important that it is
cleaned after completion of every clean
-
ing.
This prevents possible blocking of the suc
-
tion hose.
Notice:
Clean the fresh water tank filter after the
end of operation.
• Unscrew the fresh water tank filter
and remove it.
• Rinse the filter thoroughly with clean
water.
Notice:
Clean the brush whenever cleaning work
is completed.
• Place the machine on the parking
support.
A: For traction batteries; use the
parking support on the right
B: For lithium-ion batteries; use the
parking support on the left
• Screw on the triangular handle (1)
and remove the brush holder (2).
• Insert the brush into the brush hous
-
ing.
• Clean the brush roller under running water.
A
B
2
1