6 5 0 0 X T P R O C E S S C O N T R O L C H A R T
8
Process: _______________________________________
Application Use: ________________________________
Top Unwind Shaft: ______________________________
Bottom Unwind Shaft: ___________________________
Front Control Panel Settings
Top Roller Temp: _______________________________
Bottom Roller Temp: ____________________________
Main Roller Pressure: ____________________________
Cooling Fan: On ___ Off ___ Above ____ Below ____
Back Control Panel Settings
Top Pull Roller Temp: ___________________________
Pull Rollers: Up ___________/ Down ______________
Pull Roller Pressure: ____________________________
Pull Clutch Tension: ____________________________
NOTE: We recommend that you make a photocopy
of this page. With each successfully run application,
record the process and settings and a diagram of the
webbing procedure. Keep the record so the application
can be repeated at a later date.
HINT: If a standard image is made available for each
new process then sales materials and samples can be
developed for reference.
Motor Control Panel Settings
Motor Direction: Forward _______/ Reverse __________
Motor Speed Setting: ____________________________
Webbing Settings
Chill Idlers: [Over/Under] 1st / 2nd _______________
Web Tension Top Unwind Shaft:
Light ________/ Med. _________/ Heavy _________
Web Tension Bottom Unwind Shaft:
Light ________/ Med. _________/ Heavy _________
Shim Wheel Settings: Front ________/ Rear ________
Images: Sheet Fed ___________/ Roll Easel _________
Top
Main Roller
Top
Pull Roller
Front Top
Supply Shaft
Rear Top
Supply Shaft
Bottom
Main Roller
Bottom
Pull Roller
Chill
Idler
Shim Wheel
Print Guide
Front Table
Shim Wheel
Front
Rear
Front
Bottom
Wind-up
Rear
Bottom
Wind-up
Rear
Bottom
Supply
Shaft
Front
Bottom
Supply
Shaft
Rear
Roll
Easel
Front
Roll
Easel
Rear Top
Wind-up
Front Top
Wind-up
Top
Idler
Rear Table
Covered
Foot
Switch
Fan
Tube
Bott
Idler
Bott
Idler
Covered
Foot
Switch
Fan
Tube
Chill
Idler
Figure 5. Blank Webbing Diagram