PC-9
Instruction Manual.
ELEVATOR-RUDDER PUSHROD
INSTALLATION.
Elevator pushrod.
Control horn.
Rudder pushrod.
Clevis.
1) Plug the five servo leads and the switch
lead into the receiver. Plug the battery pack
lead into the switch also.
2) Wrap the receiver and battery pack in
the protective foam rubber to protect them
from vibration
INSTALLING THE RECEIVER AND BATTERY.
3) Using a 1/16” drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit. Route the antenna out of
the fuselage and secure it to the vertical stabi-
lizer using a rubber band and a modified servo
arm. See picture as below.
Antenna.
Rubber
Band.
Modified
Servo Arm.
Cut.
ATTACHMENT WING - FUSELAGE.
See picture below:
BALANCING.
1) It is critical that your airplane be bal-
anced correctly. Improper balance will cause
your plane to lose control and crash. The cen-
ter of gravity is located
8-9.5cm
back from the
leading edge of the wing, at the fuselage sides.
Balance the
PC-9
upside down with the fuel
tank empty.
2) Mount the wing to the fuselage. Using
a couple of pieces of masking tape, place them
on the top side of the wing 8cm back from the
leading edge, at the fuselage sides.
3) Turn the airplane upside down. Place
your fingers on the masking tape and care-
fully lift the plane.
Switch.
Rudder.
Throttle.
Elevator.
Receiver.
Battery.
Tie wrap.
21
