PC-9
Instruction Manual.
8
Cut.
4) Using a 1mm drill bit and the control
horns as a guide, drill the mounting holes
through the aileron halves.
6) Thread one nylon adjustable control
horn onto each aileron control rod. Thread the
horns on until they are flush with the ends of
the control rods.
5
)
Mount the control horns by inserting the
screws through the control horn bases and
aileron halves, then into the mounting
backplates. Do not overtighten the screws or
the backplates may crush the wood.
7) With the aileron servo centered and
the aileron even with the trailing edge of the
wing attach the clevis to the control horn. Mark
the control wire where it crosses the servo
arm hole.
8) Make a 90-degree bend at the mark
and cut off the excess wire leaving 10mm past
the bend.
INSTALLING THE MAIN GEAR WIRES.
1) Using a modeling knife, remove the
covering from over the two main gear mount-
ing slots located in the bottom of the wing.
9) Connect the linkage as shown and
secure the control wire with a wire keeper.
Repeat the procedure for the other
aileron servo.
2) Insert the 90º bend of one main gear
wire into the predrilled hole in one mounting
slot.
Remove covering.
Pen.
