SEA FURY.
Instruction Manual.
17
FUEL TANK.
INSTALLING THE STOPPER ASSEMBLY.
!
1) Using a modeling knife, carefully cut off
the rear portion of one of the 3 nylon tubes
leaving 1/2” protruding from the rear of the
stopper. This will be the fuel pick up tube.
!
2) Using a modeling knife, cut one length of
silicon fuel line. Connect one end of the line to
the weighted fuel pick up and the other end to
the nylon pick up tube.
INSTALLING THE ENGINE MOUNT.
See pictures below:
!
3) Carefully bend the second nylon tube up
at a 45º angle. This tube is the vent tube.
When the stopper assembly is in-
stalled in the tank, the top of the vent
tube should rest just below the top surface
of the tank. It should not touch the top of
the tank.
!
5) Test fit the stopper assembly into the
tank. It may be necessary to remove some of
the flashing around the tank opening using a
modeling knife. If flashing is present, make
sure none falls into the tank.
!
4) Carefully heat the vent tube using a
heat gun or lighter to permanently set the
angle of the tube.
Fuel Fill Tube.
Vent tube.
Fuel Pick up
Tube.
4 x 30mm.
