SEA FURY.
Instruction Manual.
24
!
3) When you are sure that everything is
aligned correctly, mix up a generous amount of
Flash 30 Minute Epoxy. Apply a thin layer to
the fuselage and to the sides and bottom of the
vertical stabilizer mounting area. Apply epoxy
to the bottom of the filler block and to the lower
hinge also. Set the stabilizer in place and re-
align. Double check all of your measurements
once more before the epoxy cures. Hold the
stabilizer in place with T-pins or masking tape
and remove any excess epoxy using a paper
towel and rubbing alcohol. Allow the epoxy to
fully cure before proceeding.
C/A glue.
CONTROL HORN INSTALLATION.
!
1) Locate the three nylon control horns,
three nylon control horn backplates and six
machine screws.
!
2) Position the two elevator horns on the
bottom side of each elevator.The clevis attach-
ment holes should be positioned over the hinge
line.
!
3) Using a 1.5mm drill bit and the control
horns as a guide, drill the mounting holes
through the elevator halves.
Mounting Plate.
Control Horn.
Mounting Screws.
C/A glue attached.
3mm x 30 mm.
2 x 20 mm ( Elevator)
2 x 30 mm ( Rudder)
Elevator
control horn.
!
4)
Mount the control horns by inserting the
screws through the control horn bases and
elevator halves, then into the mounting
backplates. Do not overtighten the screws or
the backplates may crush the wood.
!
5) Position the rudder control horn on the
right side of the airplane.
!
6) Install the rudder control horn using
the same method as with the elevator control
horns.
M3 lock nut.
M3 lock nut.
